Small Tips for YOU,please read before buying.
*Please Note that This Window Film Only Applies on Smooth Glass Surfaces.Do not Apply to Outside window or Windows with Crack.
*Don’t forget to remove transparent backing side before putting on glass or it will not cling(Use a tape on a corner of the back side (the smooth side) to quickly remove the backing protective film).
*Please use a hair dryer to soften the film under cold weather (Heat Resistant up to 176℉)
Frosted designed: brings privacy protection to your room
Suitable for: Kitchen, Living room, Bedroom, Bathroom and other places with smooth glass
Installation Instructions of YaJing Window Privacy Film Frosted Home Office Film Self-adhesive Wide Window Stickers Glass Film:
Step 1. Keep Window or Glass Clean
Step 2. Measure the window and determine size
Step 3. If you need to cut,draw lines the window film with markers. Make sure the edge of the protective film and the glass surface have a 1cm gap.
Step 4. Wet the Window or Glass with water( the more flowing water, the better)
Step 5. Remove the Static Film from backing protect sheet ( Please MAKE SURE you have removed it before you apply the matte window film to glass), if it is difficult to tear off the protective film, you can try to tape the two sides with duct tape and then peel off.
Step 6. Squeegee away air bubbles and redundant water with a scraper or hard card (Don’t move it again for 24 hours)
Step 7. Much easier than Wall Decals, 2 people work together more efficiently.
Step 8. Enjoy your works! If you want to remove it, simply peel the window film from any corner. It comes off leaving no residue cleanly.
Questions & Answers:
Q1:Why my window film can not cling?
A1:Have not wet the window with water, or have not removed the transparent backing film. Please don’t forget to remove the protective film or it will not cling.If you have removed the protective side,you may applied the wrong side. Please paste the smooth side to the window.
Q2:Why there are so many bubbles?
A2:Too less water. Please tear it down and spray a lot of water,the more water,the better.
Q3:Why the edge of my window film began to fell off?
A3:The edge of film is too close to the window. Please leave a small gap(about 1 cm )to let the water flow out so that the film can stick well.